Logo
AQUAFLEX COLOR

Acrylic copolymer based, one-component, liquid plastic coated and flexible waterproofing
material that is applied by coating.

Acrylic copolymer based, one-component, liquid plastic coated and flexible waterproofing
material that is applied by coating.

 

ADVANTAGES

  • Ready to use
  • Low labor cost
  • Maintains elasticity even at low temperature
  • Creates breathable surfaces
  • Can be diluted with water, solvent free
  • Can be painted with acrylic based paints
  • Can be colored with water based paste pigments
  • Resistant to solar rays (Minimum 1 mm)

 

PRODUCT DETAILS

 

Appearance / Color: Liquid, white
Packaging:
Available in 18-kilogram plastic buckets

 

 

TECHNICAL INFORMATION

 

Chemical Structure: Acrylic copolymer liquid
Density: 1,40 kg/dm2, + 20°C
Solid Matter Ratio: 70%, 105°C
Viscosity: 20°C , 4 sp. 6 d/d : 80.000-100.000
Elongation at break: Minimum 500 % (at 1 mm thickness + at 20°C, after 24-hour period)
Application Thickness: Optimum thickness of a layer is 1 mm and 2 to 3 coats can be applied
Contact With Water Time: Minimum 1 week

APPLICATION AREA

 

An insulation material that can be easily used by anyone for waterproof on large, very detailed, even and graded roofs, terraces and balconies; dripstones, waterways and flumes, chimney edges, fringes, gutters and drainers. It does not cause seams and suitable for all kinds ofsurfaces.

 

DETAILS OF APPLICATION

 

Consumption
Apply minimum two coats. Approximately 0.750 kg/m2 vertically and 1.0 to 1.5 kg/m2
horizontally for each coat, depending on the surface conditions.

 

APPLICATION LIMITS

 

Surface Temperature: Minimum +5° C, maximum +35°C
Ambient Temperature:
Minimum +5° C, maximum +35°C

 

APPLICATION

 

The product should be applied on liquid plastic surface with a brush and roller in one direction
and the following coat should be applied vertically in the direction of the previous coat.


Waiting time between coats: This might vary depending on the air temperature, surface
temperature, air humidity and coating thickness. The waiting time between coats is 4 to 5 hours
at 23° C and 50 % relative humidity. Make sure that the bottom coat is thoroughly dry before
applying the next coat.


Equipment cleaning: All tools and application equipment must be washed with clean water
immediately after using. Hardened / cured materials can only be cleaned mechanically.